STYLPRO Wavelength LED Face Mask Україна Доставка

• Good for: anti-aging, blemish-prone skin;
• Skin type: all skin types;
• Main benefits: includes red (633nm), blue (415nm), and near-infrared (830nm) light technology, 360 LEDs, supports collagen production, helps balance the skin and reduce inflammation, hands-free wearable design, flexible and comfortable to use, rechargeable via USB-C, 10-minute sessions, 62 mW/cm² – 129 mW/cm² output, 44 J/cm² – 77 J/cm² energy delivery;
• Time of application: daily;
• Modes: 4 (anti-aging, target, balance, recovery);
• Power source: built-in rechargeable battery;
• Plug type: USB-C cable;
• This pack contains*: 1x STYLPRO Wavelength LED Face Mask, 1x USB-C Cable, 2x Silicone Eye Comfort Pads, 2x Adjustable Mask Straps.

*Subject to change according to brand.

To assemble the STYLPRO Wavelength LED Face Mask , remove all parts from the packaging. Place the eye comfort pads into the eye openings and ensure they are securely attached. Make sure to follow the ‘R’ for right and ‘L’ for left on the eye pads. Then, attach the straps into the loops at the side of the mask. Ensure the larger end of the strap is facing upward for a secure fit around the crown of your head. Finally, plug the wire from the mask into the top of the remote. The mask will only operate when the remote is connected.

To use the STYLPRO Wavelength LED Face Mask once assembled: place the LED face mask onto your face and secure the straps around the crown of your head. Then, long-press the On/Off button on the remote to power on. Short-press the Mode button to move between the four cosmetic light settings. Once you have chosen your preferred setting, enjoy a 10-minute session. If you want to switch off the mask before the 10 minutes are complete, long-press the On/Off button. Finally, after each use, wipe down the area of the mask that has come into contact with your skin using a clean, cosmetic-safe wipe.

To charge the STYLPRO Wavelength LED Face Mask, insert the USB-C cable into the port at the top of the remote. Then, attach it to a USB-C-friendly power source. The battery icon will show a loading sequence while charging. Charging time is approximately 4 hours and 30 minutes and lasts for up to 6 uses. For best performance, use the provided charging cable. If the controller fails to charge or turn on, a reset may be required: press and hold both buttons for 20 seconds, then immediately begin charging the device. The battery icon should appear. Repeat if unsuccessful.